







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterVanities, Tile & Fixtures in Santa Ana, CA
A bathroom vanity, tile installation, and fixture replacement in Santa Ana typically runs $1,850 to $6,400 depending on whether you’re swapping a vanity top only, retiling a tub surround, or doing a full three-piece fixture change with new shut-off valves. That range covers labor and mid-grade materials for a hall bath; primary baths with double vanities, floor tile, and recessed lighting climb higher. We’re Rowan Construction Group Santa Ana, and this is the work we do most often inside 1950s and 1960s ranch homes in the Floral Park and Fisher Park historic districts, where original 4-inch square tile, cast-iron drains, and one-inch copper supply lines all need to be understood before anyone swings a hammer.
What separates this sub-service from a full bathroom remodeling is scope. You’re not moving walls or rerouting the drain stack. You’re replacing what’s worn: the vanity cabinet and countertop, the tile on the floor or walls, the faucet, the shower valve, the toilet. That narrower scope is why written pricing matters even more, because a job that starts as a faucet swap in Santa Ana can turn into a valve replacement the moment a technician opens the wall and finds galvanized pipe or a corroded angle stop. Under Clause 1 of The Haven Standard, you get a flat written price before anyone picks up a tool, and no additional work proceeds without a signed change order. Call (833) 853-5955 and we’ll walk the room with you.
Key Takeaways
- Vanity, tile, and fixture work in Santa Ana ranges from $1,850 to $6,400 for a typical hall bath.
- We name 50-plus vetted material brands up front: Kohler and Toto fixtures, Cambria and Caesarstone tops.
- Every visit includes a documented photo record and a written warranty as standard.
- Our technicians have up to 19 years of experience with tile substrate and fixture rough-in.
- The 365-Day Done Right Promise covers the work for a full year.

When You Need Vanities, Tile & Fixtures
Bathroom surfaces tell you when they’re done. Here’s what we hear from Santa Ana homeowners most often, and what each situation usually means once we get inside the wall.
- Cracked or hollow-sounding floor tile near the toilet flange. A tile that flexes underfoot means the thinset lost its bond, usually because the original install skipped a cement backer board. In Santa Ana’s older north-end homes, the subfloor is often 5/8-inch plywood laid over diagonal plank; we check the deflection before quoting tile.
- A vanity that sags at the front corners. Particleboard cabinets swell when the supply line weeps behind the toe kick, and by the time you notice the sag the cabinet box is already failing. We photograph the water stain and tell you whether the cabinet is salvageable or needs replacing.
- Faucet dripping at the base or a shower valve that only runs hot or only runs cold. On 1950s-era Santa Ana plumbing, the cartridge is often discontinued and the valve body needs replacing, not just the cartridge. That’s a different job and a different price, and you’ll know which before we start.
- Cracked caulk lines and dark grout at the tub-to-wall joint. Recurring mold at the caulk joint usually points to a failed waterproofing membrane behind the tile, not a cleaning problem. We check by probing the substrate, not by spraying bleach.
- Outdated fixture finish. Brushed nickel replacing chrome, matte black replacing oil-rubbed bronze. Cosmetic, but it drives the whole visual redo, and fixture swaps are the cheapest way to reset a bathroom’s look.
- A tile pattern you can’t live with. Pink 4-inch squares, gold-flecked 1980s marble, or a backsplash that only goes halfway up. Retiling a wall is often less disruptive than people assume when the plumbing stays put.
Our Vanities, Tile & Fixtures Process
Six steps, in order, every time. The discipline is the same in Santa Ana as anywhere else, and you’ll see it in the documentation long before you see finished tile.
- Walk the room and document everything. We photograph the existing vanity, the shut-off valves, the floor substrate at any cracked tile, and the shower valve. That photo record comes with your written estimate, not as an upgrade.
- Write the price and the scope. You get a flat written price with a written scope and a written warranty before any work starts. If you bring us a competitor’s quote, we’ll review it line by line at no charge under our Free Second Opinion offer.
- Select materials with the brand named. Your quote lists the specific vanity line, the specific countertop material, and the specific fixture model. We source across 50-plus vetted brands, including Kohler and Toto fixtures and Cambria and Caesarstone tops, so the number reflects honest material cost rather than a padded allowance.
- Protect and demo. Floors get rosin paper, the door gets a zipper, the vanity comes out whole where possible so the cabinet can be donated rather than dumped. For tile demos, we bag and haul debris; Santa Ana’s older homes often have a layer of mastic over drywall that needs careful handling.
- Prep the substrate, then install. This is where tile jobs succeed or fail. Cement backer board or a bonded waterproofing membrane goes in before a single tile; the shower pan gets a pre-slope and a flood test. Vanity goes in level and shimmed to the wall, fixtures get new supply lines and new angle stops, and every joint is caulked with a flexible sealant rather than grout.
- Walk it with you and hand over the record. You inspect the tile, the caulk lines, the water flow, and the shower valve temperature. You leave with the photo record, the signed change orders (if any), and the written warranty. Under the 365-Day Done Right Promise, if it isn’t done right, we make it right.

Vanities, Tile & Fixtures Pricing in Santa Ana
Here are honest ranges for Santa Ana work, based on 4,000-plus completed projects. These are labor and material for the scope below; your written estimate will be exact and you’ll have it before anyone starts.
| Scope | Typical Price Range |
|---|---|
| Vanity top and faucet swap only (single sink) | $420 – $950 |
| Full vanity cabinet and countertop replacement, single sink | $1,150 – $2,400 |
| Double vanity with countertop, two sinks, two faucets | $2,100 – $4,200 |
| Tile tub surround or shower surround, standard ceramic or porcelain | $1,600 – $3,400 |
| Bathroom floor tile, 40 to 60 square feet | $1,100 – $2,600 |
| Toilet replacement (standard, new wax ring and supply) | $380 – $720 |
| Shower valve replacement, including access through existing wall | $650 – $1,450 |
| Full three-piece fixture change with new shut-off valves | $1,850 – $3,900 |
What moves the number: tile selection (a large-format porcelain runs more in labor than a 4-inch square, because the substrate has to be flatter), pattern (herringbone adds 20 to 40 percent to tile labor), existing plumbing condition (galvanized pipe means cutting open the wall for a proper transition), and whether the shower gets a full waterproofing membrane and flood test. Santa Ana’s older housing stock frequently needs the last of those, and we’d rather price it into the scope than discover it later.
We don’t quote “call for a quote.” The number arrives written, with the brand and model listed, and the written scope tells you exactly what’s included. Free Second Opinion on any written estimate you already have is included too: bring a competitor’s quote and we’ll review it line by line.
What We Bring to a Santa Ana Vanity and Tile Job
Our technicians have up to 19 years of experience and arrive background-checked and uniformed. A live person answers calls 24/7, and every visit includes a documented photo record. We’re state-licensed, insured, and bonded. If you’re weighing this smaller scope against a full rebuild, our Bathroom Remodeling in Santa Ana page lays out what a full remodel covers and costs. For a clean look at the room from the ground up, our home page shows how the seven trades fit together.
FAQs – Vanities, Tile & Fixtures
How much does vanity replacement cost in Santa Ana?
Vanity replacement in Santa Ana typically costs $1,150 to $2,400 for a single-sink cabinet and countertop, and $2,100 to $4,200 for a double vanity with two sinks and faucets. Cost depends on cabinet grade, countertop material (a quartz top runs more than a solid-surface top), and whether the supply lines need new angle stops. Call (833) 853-5955 for a written price before work starts, and the estimate is free.
Can you retile a bathroom floor without replacing the vanity?
Yes, in many cases. If the vanity is sound and the floor tile runs under it, we can cut out the tile at the cabinet base and slide the new tile beneath the toe kick, keeping the existing vanity in place. If the vanity cabinet is particleboard and water-swollen, replacing it during the same visit is usually the smarter call because demo cost is shared. We tell you which you’re looking at during the walk-through.
How long does a tile and fixture job take in Santa Ana?
A vanity and fixture change is typically one to two days. Floor tile or a tub surround adds two to four days depending on dry time for thinset and grout. If we open a wall and find galvanized pipe that needs a transition to copper, that adds a day. The written schedule you receive at the start of the job is the schedule we hold ourselves to.
Is it cheaper to repair or replace an old shower valve?
Repair is cheaper when the valve body is healthy and the cartridge is available. For 1950s-era Santa Ana homes with discontinued cartridges, replacement is usually the only viable path: a new pressure-balance valve runs $650 to $1,450 installed, including cutting and patching the wall. Repairs that “work” for six months before failing again aren’t a bargain, and we’ll say so plainly.
Do you offer a warranty on tile and fixture work?
Yes. Every job is covered by the 365-Day Done Right Promise: if the work isn’t done right within the first year, we come back and make it right. The warranty is written, not a handshake, and it’s part of the flat written price and written scope you receive before work begins. Call (833) 853-5955 to schedule a free estimate.
If your vanity is sagging, your tile is cracked, or your fixture finish has aged out, the fastest path to a real price is a phone call. Reach Rowan Construction Group Santa Ana at (833) 853-5955 for a free estimate on vanities, tile, and fixtures. We’ll walk the room, photograph what we find, and hand you a flat written price before anyone picks up a tool.
Written by the team at Rowan Construction Group Santa Ana, serving Santa Ana.


