







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterWhat Cabinet Refacing Costs in Santa Ana – And Why One in Four Bungalows Costs More Than the Quote
Cabinet refacing in Santa Ana runs $4,200-$8,500 for a typical 10-linear-foot bungalow kitchen. That range covers new veneer on the boxes, new doors and drawer fronts, and hardware. But roughly one in four of Santa Ana’s older kitchens has cabinet box construction that pushes refacing past the cost of replacement – and you won’t know which category you’re in until someone inspects the boxes. We put that inspection and the final price in writing before any veneer comes off the truck. Call (833) 853-5955 for a free estimate.
Key Takeaways
- Refacing a 10-linear-foot Santa Ana kitchen costs $4,200-$8,500; a full kitchen remodel here runs $14,000-$45,000.
- Roughly 25% of pre-1960 Santa Ana cabinet boxes are built at non-standard depths (10-inch or 11.25-inch) that reject standard veneer sheets and hinges.
- Doors are the biggest single line item – 60-70% of total labor.
- A written, photo-documented box inspection is the only way to know if you’re a reface or a replace before work starts.

Why Santa Ana Bungalow Cabinets Break the Standard Reface Quote
The blocks around downtown and Lacy are packed with 1910s-1950s bungalows and Craftsman cottages. A lot of those kitchens were fitted by the builder or a later owner, not a cabinet shop. Boxes were framed on site from fir or from early particleboard, and depths rarely matched the 12-inch and 24-inch standards that modern veneer sheets and replacement hinges are cut for. We regularly pull a door off in Santa Ana and find an 11.25-inch box, or a 10-inch box on an inside corner, where a standard veneer panel simply won’t sit flush.
That’s the hidden wall. A reface quote written from a photo and a tape measure looks fine. Then the installer arrives, the veneer won’t seat, the new hinges have nothing square to bite into, and the job flips to a full cabinet replacement mid-project – often after the customer has already paid a deposit on a reface.
Older stock also carries wiring and plumbing surprises that surface once the boxes come out. Knob-and-tube-era runs and unpermitted past additions are common enough near downtown that we treat any pre-1960 kitchen wall as unknown until it’s opened. That’s why our inspection happens before the price is signed, not after.
How We Price a Reface Before Anyone Shows Up With Veneer
A technician photographs the existing box condition – depth, material, square, hinge locations, drawer glide type – and documents it before any price is agreed. The written quote then states explicitly whether the job is classified as reface or replace. Under Clause 1 of the Haven Standard, the price is written before anyone starts. And nothing switches category without a signed change order. If the boxes fail inspection after work begins, you approve the change in writing or we stop. No surprise mid-project reclassification.
This is where a documented contractor earns its keep. We’ve delivered 4,000-plus projects, every one with a written price before work started and a documented record when the crew left. Bring a competitor’s quote and we’ll review it line by line at no charge – the Free Second Opinion is a standing offer, and it’s often how Santa Ana homeowners find out their $5,000 reface quote was never going to hold.

The Real Cost Split: What You’re Actually Paying For
Lump “per linear foot” pricing hides the decisions that move your number. Here’s how the money actually divides on a Santa Ana reface.
| Line item | Cost range | What drives it |
|---|---|---|
| Veneer material (thermofoil) | $18-$24/sq ft | Lower cost, fewer finish options |
| Veneer material (real wood) | $26-$32/sq ft | Finish depth, grain matching, stain |
| Door replacement | 60-70% of total labor | The single biggest line – style, size, quantity |
| Drawer fronts | $55-$140 each | Standard vs. custom sizing on pre-1960 boxes |
| Hardware (hinges, pulls) | $12-$35 per piece | Soft-close hinges, finish |
| Box repair / custom sizing | $300-$1,200 | Non-standard depths, out-of-square boxes |
The door line is where most of the money lives – which is why the door brand matters. When a reface fails inspection and we move to replacement doors, we source KraftMaid and Wellborn. Those are real material anchors, not a vague “upgrade.” You can price a KraftMaid door against a thermofoil veneer and see exactly what the gap buys you.
For the wider scope of the room, our Kitchen Remodeling work and the Kitchen Remodeling in Santa Ana page lay out how cabinets fit into a full build. Most of what we reface in Santa Ana sits inside a kitchen that’s also getting counters and a backsplash, so the cabinet decision has to fit the whole budget, not stand alone.
Reface vs. Partial Replace vs. Full Cabinet Install: A Side-by-Side
Here’s the decision point in dollars, sized for a 10-linear-foot Santa Ana kitchen. Place your own situation against these rows.
| Option | Cost range | What you get | Best when |
|---|---|---|---|
| Full reface | $4,200-$8,500 | New veneer, doors, drawer fronts, hardware on existing boxes | Boxes are standard depth, square, sound |
| Partial replace | $7,500-$11,000 | Keep good boxes, replace failed or non-standard ones, then reface | One or two boxes fail, the rest hold |
| Full KraftMaid cabinet install | $9,000-$13,000 | All-new boxes, doors, drawers, hardware | Boxes fail across the run, or you want a new layout |
A full kitchen remodel in Santa Ana runs $14,000-$45,000 and a small kitchen remodel $9,000-$20,000, so cabinet work is usually the largest single slice of the budget. Cabinet installation on its own lands at $4,000-$13,000. Countertop installation runs $2,000-$6,500, a backsplash $800-$2,500, and a kitchen island $3,000-$10,000 – useful numbers when you’re deciding whether refacing frees up money for the rest of the room.
The clean rule: if the box inspection passes, reface. If a few boxes fail, partial replace. If the run fails across the board, a KraftMaid install is cheaper than paying twice. Because Santa Ana’s older homes often have legal-access and permit questions even on interior work – and the city’s ADU push means a lot of these kitchens sit inside homes being reworked for multigenerational use – it pays to know the whole picture before you commit.
What to Expect When We Inspect Your Santa Ana Kitchen
- A technician backgrounds-checked and in uniform, who photographs every box and documents depth and condition.
- A written quote with a flat price, written scope, and written warranty – the same on every trade, from kitchen work to home projects.
- An explicit reface-or-replace classification in writing before you sign.
- A written change order for any category switch – no work proceeds until it’s signed.
- A photo record of what we found and what we did when the crew leaves.
Every visit includes the documented photo record as standard, not an upgrade. You get the evidence, not a phone promise. And someone answers the phone 24/7 if a question comes up after the crew leaves.
FAQs
Cabinet refacing in Santa Ana typically costs $4,200-$8,500 for a standard 10-linear-foot kitchen, and around one in four older bungalows runs higher because the box construction needs custom sizing or replacement. Call (833) 853-5955 for an exact quote – estimates are free, and the price is written before any work starts.
Refacing is usually cheaper than replacing – $4,200-$8,500 versus $9,000-$13,000 for a full KraftMaid cabinet install on the same 10-linear-foot Santa Ana kitchen – if the boxes are sound and standard depth. If the boxes fail inspection, replacing can cost less than refacing a run that has to be rebuilt anyway. Call us for a free second opinion on any written estimate and we’ll review it line by line.
Pre-1960 Santa Ana cabinets were often built on site from fir or early particleboard at non-standard 10-inch or 11.25-inch depths that standard veneer sheets and new door hinges aren’t made for. That means custom sizing or replacement, which is why the box inspection has to happen before a price is signed. Call (833) 853-5955 and we’ll document your boxes first, free.
Yes – we book inspection visits across Santa Ana, including the downtown and Lacy areas, and you’ll get the written reface-or-replace price after the photographic inspection. Call (833) 853-5955 for a free estimate; a live person answers 24/7 and the written price comes before anyone picks up a tool.
Get Your Written Reface Price Before the Veneer Shows Up
Don’t sign a reface quote written from a photo. Get a Santa Ana technician to photograph your boxes, classify the job in writing, and hand you a flat price before work starts – backed by our 365-Day Done Right Promise. Call (833) 853-5955 for a free estimate, and bring any competitor’s quote for a free line-by-line second opinion.
Written by the team at Rowan Construction Group Santa Ana, serving Santa Ana, CA.
What Our Customers Say
"Final invoice was within two percent of the contract. Every change was priced and signed before anyone picked up a tool."
- Malcolm T."Driveway replaced properly with a base that will actually last. They explained why the cheaper quote was cheaper."
- Reggie O."Talked us out of the larger scope we came in asking for, because it would not have added the value we thought."
- Emil R.












